CHAPTER 7
Port and Interface Specifications
•
USB Port Specifications for an ACX5000 Router on page 57
•
Console Port Connector Pinouts for an ACX5000 Router on page 58
•
Management Port Connector Pinouts for an ACX5000 Router on page 58
•
Interface Support for an ACX5000 Router on page 59
•
Interface Specifications for SFP, SFP+, and QSFP+ Transceivers for an ACX5000
Router on page 62
•
Interface Specifications for SFP+ DAC Cables for an ACX5000 Router on page 77
•
Interface Specifications for QSFP+ DAC Breakout Cables for an ACX5000
Router on page 82
•
Interface Specifications for QSFP+ DAC Cables for an ACX5000 Router on page 86
USB Port Specifications for an ACX5000 Router
The following Juniper Networks USB flash drives have been tested and are officially
supported for the USB port in the ACX5000 routers:
•
RE-USB-1G-S—1-gigabyte (GB) USB flash drive
•
RE-USB-2G-S—2-GB USB flash drive
•
RE-USB-4G-S—4-GB USB flash drive
CAUTION: Any USB memoryproductnotlistedassupportedfortheACX5000
routers has not been testedby Juniper Networks. The use of any unsupported
USB memory product could expose your device to unpredictable behavior.
Juniper NetworksTechnicalAssistanceCenter (JTAC)can provide only limited
support forissues relatedtounsupportedhardware.We strongly recommend
that you use only supported USB flash drives.
CAUTION: Remove the USB flash drive before upgrading Junos OS or
rebooting a ACX5000 routers. Failure to do so could expose your device to
unpredictable behavior.
57Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
