Juniper ACX5048 - Page 125

•
Screws to secure the mounting rails to the chassis (provided).
•
Twelve screws for ACX5048
•
Twenty-four screws for ACX5096
•
Eight screws to secure the chassis and rear installation blades to the rack (not
provided).
•
For two-post installations (ACX5096 only):
•
One pair of mounting brackets (provided).
•
Sixteen screens for attaching the brackets to the chassis (provided).
•
Four screws to secure the mounting brackets and chassis to the post (not
provided).
•
Appropriate screwdriver for the mounting screws (not provided).
•
Two power cords with plugs appropriate to your geographical location (provided).
•
RJ-45 cable and RJ-45 to DB-9 serial port adapter (provided).
•
Management host, such as a PC laptop, with a serial port (not provided).
Optional equipment: Grounding cable kit with bracket, lug, and three nuts with integrated
washers.
WARNING: The1 U ACX5048mustbe supportedatallfourcorners.Mounting
the chassis using only the front brackets will damage the chassis and can
result in serious bodily injury.
CAUTION: All ACX5000 routers require two people for installation, one
person to lift the router into place, and another person to attach the router
to the rack. If you are installing the ACX5000 routers above 60 in. (152.4 cm)
from the floor, you can remove the power supplies and fan modules to
minimize the weight before attempting to install the router.
CAUTION: If you are mounting multiple routers on a rack, mount the router
in the lowestposition of the rackfirst. Proceed tomount the rest of the routers
from the bottom to the top ofthe rack to minimize therisk of the racktoppling.
105Copyright © 2015, Juniper Networks, Inc.
Chapter 10: Installing the Router