Figure 39: DC Power Supply Faceplate for a ACX5000 Router
5—1— ESD grounding pointShunt negative input terminals (+RTN)
6—2— Fault LEDShunt positive input terminals (–48V)
7—3— Output LEDTerminal block
8—4— Input LEDEjector lever
CAUTION: The V+ terminals are shunted internally together, as are the
V– terminals. The same polarity terminal can be wired together from the
same source to provide an additional current path in a higher power
chassis. Do not connect the terminals to different sources.
Figure 40: Securing Ring Lugs to the Terminals on the ACX5000 DC Power
Supply
8. Replace the terminal block cover.
9. Close the input circuit breaker.
119Copyright © 2015, Juniper Networks, Inc.
Chapter 11: Connecting the Router to Power
To Next Page
Loading...
