6. (Optional) Configure the name of the router. If the name includes spaces, enclose the
name in quotation marks (“ ”).
[edit]
root@# set system host-name host-name
7. Configure the default gateway.
[edit]
root@# set routing-options static route default next-hop address
8. Configure the IP address and prefix length for the router management interface.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION: Although the CLI permits you to configure two management
Ethernet interfaces within the same subnet, only one interface is usable
and supported.
NOTE: The management ports, em0 (C0) and em1 (C1) are found on the
FRU end of the ACX5000 router.
9. (Optional) Configure the static routes to remote prefixes with access to the
management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain
no-readvertise
10. Enable telnet service.
[edit]
root@# set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a ACX5000 router
through Telnet using root credentials. Root login is allowed only for SSH
access.
11. Commit the configuration to activate it on the router.
[edit]
root@# commit
Related
Documentation
• Installing and Connecting an ACX5000 Router on page 103
Copyright © 2015, Juniper Networks, Inc.126
ACX5048 and ACX5096 Universal Access Router
To Next Page
Loading...
