Table 6: CLI Equivalents of Terms Used in Documentation for an ACX5096 Router (continued)
Additional InformationItem in Documentation
Value (as displayed
in the CLI)
Description (as
displayedin the CLI)
Hardware
Item (as
displayedin
the CLI)
Interface Naming Conventions
Used in the Junos OS Operational
Commands
The router does not have
actual FPCs. In this case,
FPC refers to the router
itself.
Value of n is always 0.Abbreviated name of
the Flexible PIC
Concentrator (FPC)
FPC (n)
Interface Naming Conventions
Used in the Junos OS Operational
Commands
The router does not have
actual PIC devices; see
entries for PIC 0 for the
equivalent item on the
router.
Value of n is always 0.Abbreviated name of
the Physical Interface
Card (PIC)
PIC (n)
“ACX5000 Universal Access
Router Overview” on page 3
Built-in network ports on
the front panel of the
router
PIC 096x10G–8x40G
Port and Interface SpecificationsOptical transceiversn is a value equivalent
to the number of the
port in which the
transceiver is
installed.
Abbreviated name of
the transceiver
Xcvr (n)
“AC Power Supply for an
ACX5000 Router” on page 37
“DC Power Supply for an
ACX5000 Router” on page 39
AC power supply
DC power supply
n is a value in the
range of 0-1.
Built-in power supplyPower
supply (n)
“Cooling System and Airflow in
an ACX5000 Router” on page 33
Fann is a value in the
range of 0-2 for
ACX5096
FanFan
Figure 4: ACX5096 Interface Port Mapping
3—1— 40 Gigabit Ethernet ports (8)Electrostatic Discharge (ESD) terminal
2—10 Gigabit Ethernet ports (96)
Related
Documentation
ACX5000 Universal Access Router Overview on page 3•
9Copyright © 2015, Juniper Networks, Inc.
Chapter 1: System Overview and Architecture
To Next Page
Loading...
