DCE80-100E
Technical Handbook
Chassis
Description
3
P.Group 10
TDCE01
04GB
Chassis
The chassis consists of:
z A unit construction frame built up around two beams with a
minimum of welds for best possible strength.
z Mountings for the drive axle, steered axle, mast, lifting cylin-
ders and transmission.
z The necessary counterweights to provide a very low centre
of gravity. Moreover, the steered axle is designed to serve as
an additional counterweight.
z The hydraulic oil tank and the fuel tank are produced as sep-
arate units and are bolted to the side of the chassis. The
tanks have a low profile, which contributes to the good visi-
bility.
z Separate mounting for cab, attached with screws to the
chassis. Two different heights are available. Steps and plat-
form on the left hand side, optional also right hand side.
1. Mounting for mast
2. Mounting for tilt cylinder
3. Space for counter weights
4. Mounting for steering cylinder
5. Mounting for cab
6. Step with platform on the left
hand side of the cab, standard
7. Step with platform on the right
hand side of the cab, optional
1
2
5
4
3
6
7
Chassis
To Next Page
Loading...
