DCE80-100E
Technical Handbook
Specifications
2
P.Group 60
TDCE01
04GB
1)
Steered wheel bearings should be tightened during simulta-
neous rotation of the wheels. This makes the bearing rollers
set correctly.
Note that a jacked-up wheel gives a certain resistance when
rotated.
After tightening of steered wheel bearings, the truck should
be run for some 100 meters. After that the bearing nut should
be tightened again to 500 Nm. Then the bearing nut must not
be loosened.
Tightening torques Nm (kpm)
Wheel nuts 650 (66)
Steered wheel bearing nuts 500 (51)
1)
Nuts for upper knuckle-pin
bearings
500 (51)
Nuts for lower knuckle-pin
bearings
500 (51)
Steering cylinder,
mounting screw M20
385 (39), oiled screw
To Next Page
Loading...
