DCE80-100E
Technical Handbook
Periodic supervision
3
P.Group 90
TDCE01
04GB
General survey
To extend the service life of the truck and to prevent the risk of
faults causing injury to personnel or damage to equipment, the
truck must be subjected to regular periodic supervision.
If the truck is used under conditions in which road traffic regula-
tions are applicable, the special maintenance instructions issued
by the authorities must be followed.
The intervals at which service measures are carried out can be
determined on the basis of the operating hour meter readings.
When carrying out a 1000-hour service, it is advisable to work in
the following order:
1. Every 1000 hours
2. Every 500 hours
General survey chart
Maintenance intervals,
hours
Operating
time
1000 500 Note
200 Oil change, engine
400 Filter change, engine
500
z Guarantee service after
50 hours.
Work in accordance with
list below:
1000
zz
1500 z
2000 zz
. . .
WARRANTY SERVICE at 50 working hours
1. 500 hours service according to Technical Handbook, group 90
2. Perform and fill in control chart in the Warranty certificate
3. Changing of oil in engine, gearbox and drive axle.
4. Changing filter in engine, gearbox and hydraulic system,
(all filters incl. WDB, servo filter etc)
5. Valve clearance adjustment (engine)
6. Check all bolt joints (see also SI94-003)
To Next Page
Loading...