Keithley 6430 - Page 345

SCPI Command Reference 17-35
Use the following table to determine the parameter value for the desired
decimal digital output pattern. For non-decimal parameters, convert the dec-
imal value to its binary, octal, or hexadecimal equivalent.
The SourceMeter can be configured to place the defined “fail” bit pattern on
the digital output immediately when a “fail” condition occurs, or it can wait
until all testing on a device package is completed (operation leaves trigger
layer). See Composite testing; :BCONtrol for details.
PASS:SOURce2 <NRf> | NDN
:CALCulate2:LIMitx:PASS:SOURce2 <NRf> | <NDN> Set sorting mode “pass” pattern (x = 2, 3,
5-12)
Parameters <NRf> = 0 to 7 (3-bit) Decimal value
0 to 15 (4-bit) Decimal value
<NDN> = 0 to #b111 (3-bit) Binary value
0 to #b1111 (4-bit) Binary value
0 to #q7 (3-bit) Octal value
0 to #q17 (4-bit) Octal value
0 to #h7 (3-bit) Hexadecimal value
0 to #hF (4-bit) Hexadecimal value
OUT 4* OUT 3 OUT 2 OUT 1 Decimal value*
L
L
L
L
L
L
L
L
H
H
H
H
H
H
H
H
L
L
L
L
H
H
H
H
L
L
L
L
H
H
H
H
L
L
H
H
L
L
H
H
L
L
H
H
L
L
H
H
L
H
L
H
L
H
L
H
L
H
L
H
L
H
L
H
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
L = Low (Gnd)
H = High (>+3V)
*OUT 4 not used in 3-bit mode (values = 0 to 7)