3 Features and Functions
124 Keysight 33210A User’s Guide
Software (Bus) Triggering
The bus trigger mode is available only from the remote interface. This mode is
similar to the manual trigger mode from the front panel, but you trigger the
function generator by sending a bus trigger command. The function generator
initiates one sweep or outputs one burst each time a bus trigger command is
received.
– To select the bus trigger source, send the following command.
TRIGger:SOURce BUS
– To trigger the function generator from the remote interface (GPIB, USB, or
LAN) when the Bus source selected, send the TRIG or *TRG (trigger)
command. The front-panel key
is illuminated when the function generator
is waiting for a bus trigger.
To Next Page
Loading...
