3 Features and Functions
152 Keysight 33210A User’s Guide
Additional SCPI Configuration Commands (LAN)
There are some additional LAN configuration commands, not covered here, that
are covered in Chapter 4. See “Interface Configuration Commands” starting on
page 261 for complete information about using SCPI commands for LAN interface
control.
Keysight 33210A Web Interface
The Keysight 33210A provides a web interface resident in the instrument. You can
use this interface over the LAN to view and modify the instrument’s I/O
configuration. Also, a remote front panel interface is provided, which allows you to
control the instrument over the network.
To access and use the web interface:
1 Establish LAN interface connectivity from your PC to the 33210A.
2 Open your PC’s web browser.
3 To launch the web interface enter the IP address of the instrument, or its fully
qualified host name, in the browser address field.
4 Follow the directions in the web interface’s online help.
USB Configuration
There are no USB configuration parameters to configure. You can retrieve the USB
ID string (set by the manufacturer) by using the Show USB Id feature:
– Front panel operation: Press and press the I/O softkey. Select Show USB
Id. The USB string appears in the form:
USB ID = usb0::2391::1031::MY48nnnnnn::INSTR
where “MY48nnnnnn” is the instrument’s serial number.
– There is no SCPI command to display the USB ID.
To Next Page
Loading...
