Keysight Technologies 33210A - Sweep Commands

Remote Interface Reference 4
Keysight 33210A User’s Guide 169
Sweep Commands
(see page 223 for more information)
[1]
FREQuency
:STARt {<frequency>|MINimum|MAXimum}
:STARt? [MINimum|MAXimum]
:STOP {<frequency>|MINimum|MAXimum}
:STOP? [MINimum|MAXimum]
FREQuency
:CENTer {<frequency>|MINimum|MAXimum}
:CENTer? [MINimum|MAXimum]
:SPAN {<frequency>|MINimum|MAXimum}
:SPAN? [MINimum|MAXimum]
SWEep
:SPACing {LINear|LOGarithmic}
:SPACing?
:TIME {<seconds>|MINimum|MAXimum}
:TIME? [MINimum|MAXimum]
SWEep:STATe {OFF|ON}
SWEep:STATe?
TRIGger:SOURce {IMMediate|EXTernal|BUS}
TRIGger:SOURce?
TRIGger:SLOPe {POSitive|NEGative}
“Trig In” Connector
TRIGger:SLOPe?
OUTPut
:TRIGger:SLOPe {POSitive|NEGative}
“Trig Out” Connector
:TRIGger:SLOPe?
:TRIGger {OFF|ON}
:TRIGger?
MARKer:FREQuency {<frequency>|MINimum|MAXimum} MARKER:FREQuency?
[MINimum|MAXimum]
MARKer {OFF|ON}
MARKer?
[1] Parameters shown in bold are selected following a *RST (reset) command.