Keysight Technologies 33210A - Phase-Lock Commands; Status Reporting Commands

Remote Interface Reference 4
Keysight 33210A User’s Guide 175
Phase-Lock Commands
These commands require Option 001, External Timebase Reference (see page 266
for more information).
[1]
PHASe {<angle>|MINimum|MAXimum}
PHASe? [MINimum|MAXimum]
PHASe:REFerence
PHASe:UNLock:ERRor:STATe {OFF|ON}
PHASe:UNLock:ERRor:STATe?
UNIT:ANGLe {DEGree|RADian}
UNIT:ANGLe?
Status Reporting Commands
(see page 278 for more information)
*STB?
*SRE <enable value>
*SRE?
STATus
:QUEStionable:CONDition?
:QUEStionable[:EVENt]?
:QUEStionable:ENABle <enable value>
:QUEStionable:ENABle?
*ESR?
*ESE <enable value>
*ESE?
*CLS
STATus:PRESet
*PSC {0|1}
*PSC?
*OPC
[1] Parameters shown in bold are selected following a *RST (reset) command.