Keysight Technologies 33210A - Carrier Waveform Shape; Carrier Frequency

3 Features and Functions
88 Keysight 33210A User’s Guide
Carrier Waveform Shape
– AM carrier shape: Sine or Square waveform. The default is Sine. You cannot
use ramp, pulse, noise, dc, or arbitrary as the carrier waveform.
– Front-Panel Operation: Press either the or the front-panel function
key.
– Remote Interface Operation:
FUNCtion {SINusoid|SQUare}
You can also use the APPLy command to select the function, frequency ,
amplitude, and offset with a single command.
Carrier Frequency
The maximum carrier frequency depends on the function selected as shown
below. The default is 1 kHz for all functions.
– Front-Panel Operation: To set the carrier frequency, press the Freq softkey for
the selected function. Then use the knob or numeric keypad to enter the
desired frequency.
– Remote Interface Operation:
FREQuency {<frequency>|MINimum|MAXimum}
You can also use the APPLy command to select the function, frequency ,
amplitude, and offset with a single command.
Function Minimum Frequency Maximum Frequency
Sine
Square
1 mHz
1 mHz
10 MHz
10 MHz