Front-Panel Menu Operation 2
Keysight 33210A User’s Guide 57
To Trigger a Sweep or Burst
You can issue triggers from the front panel for sweeps and bursts using a manual
trigger or an internal trigger.
– Internal or “automatic” triggering is enabled with the default settings of the
function generator. In this mode, the function generator outputs continuously
when the sweep or burst mode is selected.
– Manual triggering initiates one sweep or outputs one burst each time you
press the key from the front-panel. Continue pressing this key to
re-trigger the function generator.
– The key is disabled when in remote (the remote icon turns on while in
remote) and when a function other than sweep or burst is currently selected
(or when the output is disabled). The key flashes off momentarily when
using a manual trigger.
To Next Page
Loading...
