3 Features and Functions
138 Keysight 33210A User’s Guide
Beeper Control
Normally, the function generator will emit a tone when an error is generated from
the front-panel or over the remote interface. You may want to disable the
front-panel beeper for certain applications.
– The beeper state is stored in non-volatile memory and does not change when
power has been off or after a remote interface reset. When shipped from the
factory, the beeper is enabled.
– Turning off the beeper does not disable the key click generated when you
press a front-panel key or turn the knob.
– Front-Panel Operation: Press and then select the Beep softkey from the
“System” menu.
– Remote Interface Operation:
SYSTem:BEEPer
Issue a single beep immediately
SYSTem:BEEPer:STATe {OFF|ON}
Disable/enable beeper
Display Bulb-Saver
The front-panel display bulb will normally turn off and the screen will go blank
after 8 hours of inactivity. For certain applications, you may want to disable the
bulb-saver feature. This feature is available from the front panel only.
– The bulb-saver setting is stored in non-volatile memory and does not change
when power has been off or after a remote interface reset. When shipped from
the factory, the bulb-saver mode is enabled.
– Front-Panel Operation: First press . From the “System” menu, press
Display Options, then press Scrn Svr (screen saver).
To Next Page
Loading...
