6 Application Programs
330 Keysight 33210A User’s Guide
Introduction
Six example programs are included in this chapter to demonstrate controlling the
Keysight 33210A using SCPI commands. All of these programs are written in
Microsoft
®
Visual BASIC
®
6.0 and use Keysight VISA-COM.
The BASIC programs in this chapter, and other example programs illustrating the
use of several drivers and environments, are included on the “Keysight 33210A
Product Reference CD-ROM” shipped with the function generator. For a detailed
description of these programs, refer to the “readme” file in the “Examples”
directory. The programs in this chapter are found in the “Examples\chapter6”
subdirectory.
If you want to modify the example programs, or write your own programs and
compile them, you will need to install the Keysight IO Libraries Suite software. You
can install this software from the “Keysight E2094 Automation-Ready CD-ROM”
that is also provided with the 33210A.
You may have previously installed the IO Libraries Suite software that was
provided with other Keysight products (such as an KeysightGPIB card). However,
you must have Keysight IO Libraries Suite 14.0 or a later version to support the
examples that are provided on the Product Reference CD-ROM.
Microsoft
®
and Visual BASIC
®
are U.S. registered trademarks of Microsoft
Corporation.
Once you have installed the appropriate software components, see Remote
Interface Configuration in Chapter 3 for information on configuring your interface.
For information on obtaining the Keysight IO Libraries Suite software, see:
www.keysight.com/find/iolib
To Next Page
Loading...
