Keysight Technologies 33210A - Burst Commands

4 Remote Interface Reference
170 Keysight 33210A User’s Guide
Burst Commands
(see page 229 for more information)
[1]
BURSt:MODE {TRIGgered|GATed}
BURSt:MODE?
BURSt:NCYCles {<# cycles>|INFinity|MINimum|MAXimum}
BURSt:NCYCles? [MINimum|MAXimum]
BURSt:INTernal:PERiod {<seconds>|MINimum|MAXimum}
BURSt:INTernal:PERiod? [MINimum|MAXimum]
BURSt:PHASe {<angle>|MINimum|MAXimum}
BURSt:PHASe? [MINimum|MAXimum]
BURSt:STATe {OFF|ON}
BURSt:STATe?
UNIT:ANGLe {DEGree|RADian}
UNIT:ANGLe?
TRIGger:SOURce {IMMediate|EXTernal|BUS}
Triggered Burst
TRIGger:SOURce?
TRIGger:SLOPe {POSitive|NEGative}
“Trig In” Connector
TRIGger:SLOPe?
BURSt:GATE:POLarity {NORMal|INVerted}
External Gated Burst
BURSt:GATE:POLarity?
OUTPut
:TRIGger:SLOPe {POSitive|NEGative}
“Trig Out” Connector
:TRIGger:SLOPe?
:TRIGger {OFF|ON}
:TRIGger?
[1] Parameters shown in bold are selected following a *RST (reset) command.