5 Error Messages
326 Keysight 33210A User’s Guide
Arbitrary Waveform Errors
The following errors indicate failures that may occur during arbitrary waveform
operation. Refer to “Arbitrary Waveform Commands (Option 002)” on page 240 for
more information.
770
Nonvolatile arb waveform memory corruption detected
The non-volatile memory used to store arbitrary waveforms
has detected a
checksum error. The arbitrary waveform cannot be retrieved from memory.
781
Not enough memory to store new arb waveform; use DATA:DELETE
The four non-volatile memory locations already contain arbitrary waveforms. To
store another waveform, you must first delete one of the stored waveforms using
the DATA:DELete command.
781
Not enough memory to store new arb waveform; bad sectors
Due to a hardware error, there are no more memory locations available to store
arbitrary waveforms. This error is likely the result of a failed Flash memory device.
782
Cannot overwrite a built-in waveform
The following built-in waveform names are reserved and cannot be used with the
DATA:COPY command: “EXP_RISE”, “EXP_FALL”, “NEG_RAMP”, “SINC”, and
“CARDIAC”.
784
Name of source arb waveform for copy must be VOLATILE
When using the
DATA:COPY
command, you cannot copy
from
any source other than
“VOLATILE”.
To Next Page
Loading...
