Keysight Technologies 33210A - Page 136

3 Features and Functions
136 Keysight 33210A User’s Guide
– Front-Panel Operation: Press and then select the Store State or Recall
State softkey. To delete a stored state, select the Delete State softkey (also
removes the custom name for this memory location).
To configure the function generator to recall the factory default state at
power-on, press and then select the Pwr-On Default softkey. To
configure the function generator to recall the power-down state
when power is
restored, press and select the
Pwr-On Last softkey.
You can assign a custom name to each of the four storage locations.
– The custom name can contain up to 12 characters. The first character
must
be a letter but the remaining characters can be letters, numbers
, or the
underscore character (“ _ ”).
– To add additional characters, press the right-cursor key until the cursor is
to the right of the existing name and then turn the knob.
– To delete all characters to the right of the cursor, press the key.
– Remote Interface Operation:
*SAV {0|1|2|3|4}
State 0 is the instrument state at power down.
*RCL {0|1|2|3|4} States 1, 2, 3, and 4 are user-defined states.
To assign a custom name to a stored state to be recalled from the front panel,
send the following command. From the remote interface, you can only recall a
stored state using a number (0 through 4).
:STATE:NAME 1,TEST_WFORM_1
To configure the function generator to automatically recall the power-down
state when power is restored, send the following command.
MEMory:STATe:RECall:AUTO ON