4 Remote Interface Reference
210 Keysight 33210A User’s Guide
AM:STATe {OFF|ON}
AM:STATe?
Disable or enable AM. To avoid multiple waveform changes, you can enable AM
after you have set up the other modulation parameters. The default is OFF.
The :STAT? query returns “0” (OFF) or “1” (ON).
– The function generator will allow only one modulation mode to be enabled at a
time. For example, you cannot enable AM and FM at the same time. When you
enable AM, the previous modulation mode is turned off.
– The function generator will not allow AM to be enabled at the same time that
sweep or burst is enabled. When you enable AM, the sweep or burst mode is
turned off.
To Next Page
Loading...
