4 Remote Interface Reference
220 Keysight 33210A User’s Guide
PWM:STATe {OFF|ON}
PWM:STATe?
Disable or enable PWM. To avoid multiple waveform changes, you can enable
PWM after you have set up the other modulation parameters. The default is OFF.
The :STAT? query returns “0” (OFF) or “1” (ON).
– The function generator will allow only one modulation mode to be enabled at a
time. For example, you cannot enable PWM and AM at the same time. When
you enable PWM, the previous modulation mode is turned off.
– The function generator will not allow PWM to be enabled at the same time
that sweep or burst is enabled. When you enable PWM, the sweep or burst
mode is turned off.
– PWM is allowed only when pulse is the selected function.
To Next Page
Loading...
