Remote Interface Reference 4
Keysight 33210A User’s Guide 271
The Status Byte condition register is cleared when:
– You execute the *CLS (clear status) command.
– You read the event register from one of the other register groups (only the
corresponding bits are cleared in the condition register).
The Status Byte enable register is cleared when:
– You execute the *SRE 0 command.
– You turn the power on and have previously configured the function generator
to clear the enable register using the *PSC 1 command. Note that the enable
register will not be cleared at power-on if you have configured the function
generator using the *PSC 0 command.
To Next Page
Loading...
