2 Front-Panel Menu Operation
62 Keysight 33210A User’s Guide
displayed:
Contact your network administrator for the IP address to use. All IP
addresses take the dot-notation form “nnn.nnn.nnn.nnn” where “nnn” in
each case is a byte value in the range 0 through 255. You can enter a new
IP address using the numeric keypad (not the knob). Just type in the
numbers and the period delimiters using the keypad. Use the left cursor
key as a backspace key. Do not enter leading zeros. For further information,
see More about IP Addresses and Dot Notation at the end of this section.
b Set the “Subnet Mask.” The subnet mask is required if your network has
been divided into subnets. Ask your network administrator whether a
subnet mask is needed, and for the correct mask. Press the Subnet Mask
softkey and enter the subnet mask in the IP address format (using the
keypad).
c Set the “Default Gateway.” The gateway address is the address of a
gateway, which is a device that connects two networks. Ask your network
administrator whether a gateway is in use and for the correct address.
Press the Default Gateway softkey and enter the gateway address in the IP
address format (using the keypad).
d Exit the “IP Setup” menu. Press DONE to return to the “Modify Settings”
menu.
To Next Page
Loading...
