Keysight 81150A - Page 106

Appendix
106
Remote Interface
Operation
The following function is used to configure the output amplitude remotely:
:VOLTage[1|2] {<NR3>|MINimum|MAXimum}
Or, you can set the amplitude by specifying a high level and low level using
the following commands.
:VOLTage[1|2]:HIGH {<volts>|MINimum|MAXimum}
:VOLTage[1|2]:LOW {<volts>|MINimum|MAXimum}
You can also use the APPLy command to select the function, frequency,
amplitude, and offset with a single command.