Front-Panel Menu Operation
81150A and 81160A User’s Guide 75
2.28 Outputting a Burst Waveform
You can configure the 81150A / 81160A to output a waveform with a
specified number of cycles, called a burst. You can output the burst at a rate
determined by the internal rate generator or the signal level on the Front
Panel External In.
For this example, you will output a three-cycle sine wave with a 20 ms burst
period. You will not change the other parameters from their default settings:
internal burst source and 0 degree starting phase.
Press to enable or disable burst mode. Notice that a status message
Burst is shown in the status line.
Press the #Cycles softkey and then set the count to “3” using the numeric
keypad or knob.
To Next Page
Loading...
