Keysight 81150A - FSK Carrier Frequency

Appendix
210
3.10.3 FSK Carrier Frequency
Introduction
The maximum carrier frequency depends on the function selected as shown
below. The default is 1 MHz for all functions.
Function
Minimum Frequency
Maximum Frequency
Sine
1 Hz
81150A: 240 MHz
81160A: 500 MHz
Square
1 Hz
81150A: 120 MHz
81160A: 330 MHz
Ramp
1 Hz
81150A: 5 MHz
81160A: 20 MHz
Arbs
1 Hz
81150A: 120 MHz
81160A: 330 MHz
FSK Carrier
Frequency
Characteristics
When the External source is selected, the output frequency is determined
by the signal level on the Modulation In connector. When a logic low level is
present, the carrier frequency is output. When a logic high level is present,
the hop frequency is output.
Front-Panel
Operation
To set the carrier frequency, press the Frequency softkey for the selected
function. Then use the knob or numeric keypad to enter the desired
frequency.
Remote Interface
Operation
:FREQuency[1|2] {<frequency>|MINimum|MAXimum}
You can also use the APPLy command to select the function, frequency,
amplitude, and offset with a single command.