Keysight 81150A - Factory Default Settings

Appendix
294
3.21 Factory Default Settings
Introduction
The table on the following page summarizes the factory default settings for
the Keysight 81150A / 81160A.

 The power-on state will be different than that in the table if you have
enabled the power-down recall mode. See “Instrument State
Storage”.
Keysight 81150A / 81160A Factory Default Settings
 Output Configuration
Factory Setting
Function
Sine wave
Frequency
1 MHz
Amplitude/Offset
1 Vpp/0.000 Vdc
Output Units
Vpp
Output Impedance
50
Output Termination
50 (81150A only)
Polarity
Normal
Autorange
On
Amplifier Type
Max. Bandwidth (81150A only)
Trigger-Out
TTL (81150A only)
Strobe-Out
TTL (81150A only)
Sync-Out A
Sync-Out B
Output State
TTL (81160A only), Logical Trigger Signal 1
TTL (81160A only), Logical Strobe Signal 1
Off
 Timing Configuration
Factory Setting
Delay
Os (Pulse, Sine, Square, Ramp, Arb)
Width (Pulse)
50 ns
Lead Edge (Pulse)
81150A: 2.5 ns
81160A: 1.2 ns
Duty Cycle (Square)
50%