Keysight 81150A - Selecting DC Volts

Appendix
50
2.15 Selecting DC Volts
Introduction
You can select the "DC Volts" feature from the “Utility” menu, and then set
a constant dc voltage as an "Offset" value. As an example, let us set "DC
Volts" = -1.5 Vdc.
To select DC Volts
Steps:
 Press and then press the DC Mode softkey.
 Press the DC softkey to toggle between DC mode off and on. When
DC mode is being turned off, then the instrument will switch back to
the parameter screen of the waveform being generated.