Keysight 81150A - Keysight 81150 A; 81160 A in Comparison with Other Keysight Instruments; Keysight 81110 A;81104 A;81101 A Instrument Family

Appendix
81150A and 81160A User’s Guide 663
A.3 Keysight 81150A / 81160A in comparison with other Keysight
instruments
A.3.1 Keysight 81110A/81104A/81101A instrument family
Introduction
The implemented SCPI command set is based on Keysight’s
81110A/81104A/81101A Pulse/Data Generator product family. Most of the
SCPI commands available for that instrument family are also available in the
Keysight 81150A / 81160A instrument. The following table lists the SCPI
commands which are not available in 81150A / 81160A as compared to the
above-mentioned instruments.
Pattern Data SCPI subsystem
Set/read pattern data
:DIGital[:STIMulus]:PATTern:DATA[1|2|3] [<start>,] <data>
Set PRBS 2n-1 data
:DIGital[:STIMulus]:PATTern:PRBS[1|2|3] [<n>,] <length>
Set present pattern with clock divided by n
:DIGital[:STIMulus]:PATTern:PRESet[1|2|3] [<n.,] <length>
Switch pattern mode on|off
:DIGital[:STIMulus]:PATTern[:STATe] {ON|OFF}
Update the hardware with pattern
:DIGital[:STIMulus]:PATTern:UPDate {ON|OFF|ONCE}
Set/read the format of output channel
:DIGital[:STIMulus]:SIGNal[1|2]:FORMat {RZ|NRZ}
Current SCPI subsystem
Switches between Voltage/Current
[:SOURce]:HOLD[1|2] VOLT|CURR