Keysight 81150A - Host Name

Features and Functions
81150A and 81160A User’s Guide 279
3.16.6 Host Name
Introduction
A host name is the host portion of the domain name, which is translated
into an IP address.
Setting up a Host
Name
 Contact your network administrator for the correct host name.
 Enter the host name using the knob and cursor keys. Each character
in the name can be a letter ("a" through "z"), number, or dash ("-").
 Use the knob to select each character.
 Use the cursor key to move to the next character.
 You can use the keypad for numbers.
 The host name is stored in non-volatile memory and does not change
when power has been off or after a remote interface reset.
Front panel
operation
 Press and then the I/O Interfaces softkey.
 Then select LAN, followed by DNS Setup.
 Then select Host Name.
 There is no SCPI command to set a host name.