Keysight 81150A - Sweep Type

Appendix
232
3.12.5 Sweep Type
Introduction
You can sweep with either linear or logarithmic spacing. The default is
Linear.
For a linear sweep, the 81150A / 81160A varies the output frequency in a
linear fashion during the sweep.
For a logarithmic sweep, the 81150A / 81160A varies the output frequency in
a logarithmic fashion.
Front-Panel
Operation
After enabling , press the Sweep Type softkey again to toggle
between the Linear or Logarithmic mode.
Remote Interface
Operation
:SWEep[1|2]:SPACing {LINear|LOGarithmic}