Appendix
168
3.5.6 Bitshape Selection
If the bit shape parameter on the pattern setup screen is set to Arbitrary, it
is possible to select a predefined or use a userdefined waveform that
defines the shape of a bit. The screens operate similar to the standard Arb
mode.
For details on arbitrary bit shapes, refer to section Defining the Shape of a
Bit.
After selecting the Pattern Setup softkey on the Pulse screen, press MORE
1 of 2 and then press the Bit Shape softkey to choose from Arbitrary or NRZ.
Remote Interface
Operation
:DIGital[1|2]:SIGNal:FORMat {NRZ|USER}
After selecting the Bit Shape softkey, press the Select Bit Waveform
softkey. This brings you to the following screen.
To Next Page
Loading...
