Keysight 81150A - Selecting the Mode of Operation

Appendix
32
2.8 Selecting the Mode of Operation
Introduction
The Mode of operation consists of the following four components:
 Coupling between Ch1 & Ch2
 Trigger Mode
 Waveform Type
 Advanced Modes
These are further explained below:
Coupling between
Ch1 & Ch2
There are two output channels available for the Keysight 81150A / 81160A.
The 2 channel version operates in two different modes of operation:
Coupling off: The two channels operate entirely independent. Frequency
generation for both channels is based on the same clock reference.
Coupling on: The frequency, trigger mode, waveform type and advanced
mode are identical for both channels. The delay between the channels is
specified.
Refer to the Appendix for a list of all coupled parameters.
The Trigger Mode, Waveform Type and the Advanced Modes are explained
in the following sections.