Keysight 81150A - Selecting FSK Modulation

Appendix
208
3.10.1 Selecting FSK Modulation
Introduction
The 81150A / 81160A will allow only one modulation mode to be enabled at
a time. For example, you cannot enable FSK and AM at the same time.
When you enable FSK, the previous modulation mode is turned off.
The 81150A / 81160A will not allow FSK to be enabled at the same time that
sweep or burst is enabled. When you enable FSK, the sweep or burst mode
is turned off.
Front-Panel
Operation
You must enable FSK before setting up any of the other modulation
parameters. Press and then press the Modulation Type softkey to
select FSK. The FSK waveform is output using the present settings for the
carrier frequency, output amplitude, and offset voltage.
Remote Interface
Operation
To avoid multiple waveform changes, enable FSK after you have set up the
other modulation parameters.
:FSKey[1|2]:STATe {ON|OFF}