Keysight 81150A - Preparing the 81150 A; 81160 A for Use

Appendix
30
2.6 Preparing the 81150A / 81160A for Use
Check the List of
supplied items
Before preparing the 81150A / 81160A for use, check the list of supplied
items, given below:
 One Power Cord
 USB Cable
 Product CD
 This User’s Guide (if ordered in printed version)
 Getting Started Guide (if ordered in printed version)
 Certificate of Calibration
 Keysight Automation Ready CD
Connect the Power
Cord and turn on
the 81150A /
81160A
The instrument runs a short power-on self test, which takes about 45-50
seconds. The 81150A / 81160A powers up in the sine wave function at 1
MHz with an amplitude of 1 Vpp (into a 50 termination) or the power-down
setting. At power-on, the Output connector is disabled. To enable the Output
connector, press the output key.
If the 81150A /
81160A does not
turn on….
Steps:
 Verify that the power cord is firmly connected to the power
receptacle on the rear panel (the power-line voltage is automatically
sensed at power-on).
 You should also make sure that the 81150A / 81160A is connected to
a power source that is energized.
 Then, verify that the 81150A / 81160A is turned on.
If the power-on tests fail, the instrument automatically switches to the
diagnostics screen and displays the power on messages.