Keysight 81150A - Pattern Related Commands

Appendix
536
4.5.16 Pattern Related Commands
Command
:DIG:SIGN:FORM
Long
:DIGital[1|2][:STIMulus]:SIGNal:FORMat[?]
Parameters
NRZ|USER
Parameter Suffix
–
Description
This command is used to set the bit shape in pattern mode. Setting the
bitshape to NRZ causes the output signal to be equal to high level for a ‘1’
bit and equal to low level for a ‘0’ bit and equal to offset for a ‘-‘bit. In NRZ
mode, the transition times can be adjusted using the leading edge parameter
(:PULS:TRAN).
If bitshape is set to USER, the bit transitions can be defined using the
:DIG:TRAN command.
Example
:DIG:SIGN:FORM NRZ