Keysight 81150A - Setting a DC Offset Voltage

Front-Panel Menu Operation
81150A and 81160A User’s Guide 51
2.16 Setting a DC Offset Voltage
Introduction
At power-on, normally, the instrument outputs the same setting as before
power-down.
The following steps show you how to change the offset.
Press the “Offset”
softkey
Steps:
 Press the Offset softkey to select the DC offset voltage. Enter the
desired voltage level as an “Offset” (as shown in the image below)
When you change functions, the same offset is used if the present value is
valid for the new function.
Enter the
magnitude of the
desired offset
Using the numeric keypad, enter the value “-1.5” (as shown in the image
below).