Keysight 81150A - Configuring the Remote Interface; GPIB Configuration

Appendix
82
2.31 Configuring the Remote Interface
Introduction
This section gives information on configuring the 81150A / 81160A for
remote interface communication. For information on the SCPI commands
available to program the 81150A / 81160A over the remote interface, refer to
chapter 4.
The Keysight 81150A / 81160A supports remote interface communication
using a choice of three interfaces: GPIB, USB, and LAN, explained below. All
three interfaces are "live" at power up. The instructions that follow explain
how to configure your remote interface from the instrument front panel.
The CD-ROM provided with your instrument contains connectivity software
to enable communications over these interfaces. Refer to the instructions
provided on the CD-ROM to install this software on your PC.
2.31.1 GPIB Configuration
Introduction
Each device on the GPIB interface must have a unique address. The address
is stored in the non-volatile memory and does not change when power has
been off or after a remote interface reset.
Follow these steps to set the GPIB address:
Select the “I/O”
menu
Press and then press the I/O Interfaces softkey.