Keysight 81150A - Selecting a Burst

Features and Functions
81150A and 81160A User’s Guide 239
3.13.1 Selecting a Burst
Introduction
The 81150A / 81160A will not allow the burst to be enabled at the same
time that sweep or any modulation mode is enabled.
When you enable burst, the sweep or modulation mode is turned off.
Front-Panel
Operation
You must enable burst before setting up any of the other burst parameters.
Press to output a burst using the present settings for frequency,
output amplitude, and offset.
Remote Interface
Operation
To avoid multiple waveform changes, enable the burst mode after you have
set up the other parameters.
:BURSt[1|2]:STATe {OFF|ON}
:TRIGger[1|2]:COUNt {<#cycles>}
Burst is enabled if the number of cycles to generate bursts is 2 or greater
than 2.