Front-Panel Menu Operation
81150A and 81160A User’s Guide 41
2.11.2 Burst
You can configure the 81150A / 81160A to output a waveform with a
specified number of pulses/waveform cycles, called a burst. You can output
the burst at a rate determined by the internal rate generator or the signal
level on the Front Panel External In connector.
A burst can be initiated either by:
An Internal Immediate event, which triggers a continuous burst.
A trigger source, which triggers a triggered burst.
An active gate, which enables a gated burst.
Select the function
and amplitude for
the burst
For burst waveforms, you can select sine, square, ramp, pulse, or arbitrary
waveforms.
Burst mode cannot be used when using DC or noise.
Press and specify the #Cycles and the Start Phase softkeys
to set the desired values.
The Start Phase defines the phase at which signal generation starts.
The allowed range is -360 to +360. It is only applicable to Sine and
Arb waveforms.
Refer to Outputting a Burst Waveform for details.
To Next Page
Loading...
