Features and Functions
81150A and 81160A User’s Guide 227
3.12.1 Selecting a Sweep
The 81150A / 81160A will not allow the sweep mode to be enabled at the
same time that burst or any modulation mode is enabled.
When you enable sweep, the burst or modulation mode is turned off.
You must enable sweep before setting up any of the other sweep
parameters. Press to output a sweep using the present settings for
frequency, output amplitude, and offset.
Remote Interface
Operation
To avoid multiple waveform changes, enable the sweep mode after you have
set up the other modulation parameters.
:SWEep[1|2]:STATe {ON|OFF}
To Next Page
Loading...
