Appendix
74
If desired, you can set the frequency boundaries of the sweep using a center
frequency and frequency span. These parameters are similar to the start
frequency and stop frequency and are included to give you added flexibility.
To achieve the same results, set the center frequency to 2.525 kHz and the
frequency span to 4.950 kHz.
Press to view the waveform parameters.
To turn off the Graph Mode, press again.
You can generate a single frequency sweep by pressing the
key, but only if triggered mode is active.
The 81150A / 81160A can also have gated sweeps. In this case it will
start a new sweep as long as the gate is active. If the gate is getting
inactive while a sweep is generated, this sweep will be finished. For
more information, see “Triggering a Sweep or Burst”.
To Next Page
Loading...
