Keysight 81150A - Page 237

Features and Functions
81150A and 81160A User’s Guide 237
Remote Interface
Operation
Use the following command to specify whether the 81150A / 81160A
triggers on the rising or falling edge of the signal on the External In
connector.
:ARM:SOURce{IMMediate|INTernal[1]|INTernal[2]|
EXTernal|MANual}
:ARM:FREQuency[1|2] {<frequency>|MAXimum|MINimum}
:ARM:SENSe[1|2]{EDGE|LEVel}
:ARM:PERiod[1|2] {<seconds>|MAXimum|MINimum}
:ARM:SLOPe {POSitive|NEGative|EITHer}
For more information, refer to the Triggering Commands section.