Delete the specified arbitrary waveform from memory. You can delete the
waveform in volatile memory or any of the four user-defined waveforms in
non-volatile memory.
You cannot delete the arbitrary waveform that is currently being output. If
you attempt to delete this waveform, a “Not able to delete the currently
selected active arb waveform” error is generated.
You cannot delete any of the seven built-in arbitrary waveforms. If you
attempt to delete one of these waveforms, a “Not able to delete a built-in
arb waveform” error is generated.
Use the DATA:DEL:ALL command to delete the waveform in volatile
memory and all user-defined non-volatile waveforms all at once.
If one of the waveforms is currently being output, a “Not able to delete the
currently selected active arb waveform” error is generated.
To Next Page
Loading...
