Keysight 81150A - Page 360

Appendix
360
Command
:UNIT[1|2]:ANGL[?]
Long
:UNIT[1|2]:ANGLe[?]
Parameters
{DEGree|RADian}
Parameter Suffix

Description
Select degrees or radians to set the phase offset value (remote interface
only). The default is DEG. The :ANGL? query returns “DEG” or “RAD”.
From the front panel, the phase offset is always displayed in degrees
(radians are not available). If you set the phase offset in radians from the
remote interface and then return to front-panel operation, you will see that
the instrument converts the phase offset to degrees.
Example
:UNIT:ANGL RAD