Keysight 81150A - Page 384

Appendix
384
Command
:FM[1|2]:INT:FREQ[?]
Long
[:SOURCE]:FM[1|2]:INTernal:FREQuency[:CW|:FIXed]
[?]
Parameters
{<NR3>|MINimum|MAXimum}
Parameter Suffix
HZ
Description
Set the frequency of the modulating waveform. Used only when the Internal
modulation source is selected (FM[1|2]:SOUR INT command). The
:FM[1|2]:INT:FREQ? query returns the internal modulating frequency
in Hertz. It doesn’t apply if “INT2” is selected.
Example
:FM2:INT:FREQ 20KHZ