Keysight 81150A - Page 395

Remote Programming Reference
81150A and 81160A User’s Guide 395
Command
:FSK[1|2]:STAT[?]
Long
[:SOURCE]:FSKey[1|2]:STATe[?]
Parameters
{ON|OFF}
Parameter Suffix

Description
Disable or enable FSK modulation. To avoid multiple waveform changes, you
can enable FSK after you have set up the other modulation parameters. The
default is OFF. The :FSK1:STAT? query returns “0” (OFF) or “1” (ON).
The instrument will allow only one modulation mode to be enabled at a time.
For example, you cannot enable FSK and AM at the same time. When you
enable FSK, the previous modulation mode is turned off. The instrument will
not allow FSK to be enabled at the same time that sweep or burst is
enabled. When you enable FSK, the sweep or burst mode is turned off.
Example
:FSK1:STAT ON