Keysight 81150A - Page 400

Appendix
400
Command
:PM[1|2]:INT:FREQ[?]
Long
[:SOURCE]:PM[1|2]:INTernal:FREQuency[:CW|:FIXed]
[?]
Parameters
{<NR3>|MINimum|MAXimum}
Parameter Suffix
HZ
Description
Set the frequency of the modulating waveform. Used only when the Internal
modulation source is selected (PM[1|2]:SOUR INT command). The
:PM[1|2]:INT:FREQ? query returns the internal modulating frequency
in Hertz. It doesn’t apply if “INT2” is selected.
Example
:PM:INT:FREQ 1.2 MHZ