Keysight 81150A - Page 458

Appendix
458
Command
:PULS:TDEL[1|2][?]
Long
[:SOURce]:PULSe:TDELay[1|2][?]
Parameters
{<NR3>|MINimum|MAXimum}
Parameter Suffix
S
Description
Set the delay of the trailing edge of the pulse relative to start of pulse
period. This is an alternative method of programming pulse width.
 This command is affected by the :PULS:HOLD[1|2] command, which
determines the value to be held constant as the period is adjusted: the
specified pulse width value, or the specified pulse duty cycle value, or the
specifies trailing delay. See the :PULS:HOLD[1|2] command for further
information.
Example
:PULS:TDEL1 6.77NS